
Roofing in Tempe and the Surrounding Towns
We repair, replace and install tile, shingle, foam and flat roofs for homeowners in Tempe and nearby towns. Each job is planned around how your roof was built and how it has aged, so the finished work fits your home and holds up through long summers.
Towns we cover from Tempe
- Tempe
- Guadalupe
- Chandler
- Mesa
- Gilbert
- Sun Lakes
- Paradise Valley
- Glendale
Not on the list? Call (480) 351-3961 and ask.

Where Our Crews Work
Most of our work is in Tempe and the towns that border it. We regularly drive to Guadalupe, Mesa and Chandler, and south to Gilbert and Sun Lakes. Our schedule also reaches Paradise Valley and Glendale, so if your home sits a little farther out, it is still worth a conversation.
The roofs across these towns share a lot. Concrete tile over pitched sections is common. Many older ranch homes have low-slope or flat areas covered in foam or rolled material, and a fair number of houses carry asphalt shingles. We handle tile roofing, shingle roofing, foam roofing and flat roofing in every town on this page. That means you get the same materials, the same crew habits and the same cleanup whether you live a few blocks away or across the Valley.
What Shapes a Roof Job Here
- 01
Housing age
Many homes in the area were built between the 1960s and the early 2000s. On tile roofs from those decades, the tile itself is often sound while the underlayment beneath it has dried out and cracked. We look at both layers before recommending anything, because relaying good tile over new underlayment can cost far less than a full tear-off. Older flat sections are a different story. Their foam or coating may simply be worn thin.
- 02
Heat and sun
Long stretches of triple-digit heat and strong sun are hard on every roofing material. Shingles lose granules and turn brittle. Foam needs its protective coating renewed before UV reaches the foam underneath. Sealants at vents and flashings shrink and pull away. We choose materials and coatings with that exposure in mind, and we schedule work for early hours in summer so adhesives and sealants set properly.
- 03
Monsoon season
Summer monsoon storms bring sudden wind and heavy rain to roofs that have baked for months. That is when weak flashing, slipped tiles and ponding on flat roofs show up as leaks. Planning repairs or a roof replacement in spring or fall gives you a sound roof before the next storm season and a calmer schedule for everyone.
- 04
HOAs and permits
Many neighborhoods across these towns have HOAs with rules on tile profile and color. Each city also has its own permit process for roof replacement and new roof installation. We check what applies to your address, pull the permit where one is required and match the approved material, so your new roof passes review and looks right on your street.

Start With a Conversation About Your Home
Let us know which town you are in and what has caught your eye on the roof, from a slipped tile to a soft spot on a flat section. We will walk you through the likely cause, which of our services suits it and how we would plan the work.